Dräger X-zone 5500 Instrucciones De Uso página 52

Establishing a wireless connection
4.2.6 Terminating group
1. Press the key on the main device to open the menu.
OK
2. Select and confirm .
3. Select and confirm
Display on main and group devices:
Grouping LED: off.
4.2.7 Provisionally disabling group monitoring
If group monitoring is provisionally disabled, the associated
device alarm function is provisionally disabled as a result.
The connection status display, the group assignment for the
devices and the forwarding of gas alarms are retained.
To disable the group monitoring provisionally:
1. Form group with closed wireless network.
2. Press the key on the main device to open the menu.
OK
3. Select and confirm .
4. Select and confirm
provisionally.
Group monitoring is disabled.

Group monitoring is automatically activated 15 minutes after
provisional deactivation or after switching on grouped devices.
This interval is shown as follows:
For the first 13 minutes the communication LED flashes

slowly.
For the last 2 minutes the communication LED flashes

quickly.
NOTICE
i i
The gas alarms remain displayed if group monitoring is
disabled.
52
to ungroup the group.
ARCL-0144
to disable the group monitoring
4.2.8 Activating group monitoring
1. Form group with closed wireless network.
2. Press the
OK
3. Select and confirm
4. Select and confirm
Group monitoring is activated.

4.2.9 Terminating group in an alarm situation
If the main device can no longer be found for a group device
(communication LED flashes red), the grouping for this device
can be cleared.
To ungroup the group:
1. Press the
OK
2. Select and confirm
3. Select and confirm to delete the group affiliation.
or
Press key on the group device for a long time.

Group affiliation is deleted.

04333112.eps
4.2.10 Open quick menu of the X-am 5x00
Use this function to open the quick menu of the X-am 5x00
To open the quick menu:
1. Press the
OK
2. Select Quick to display the quick menu of the X-am
5x00.
4.2.11 Open status indicator from external module
NOTICE
i i
This function is only available if the Modbus function
using the PC software CC-Vision has been enabled.
1. Press the
OK
2. Select Modbus to
display the status indicator.
Legend:
1 Equipment name
2 GSM signal strength
3 Phone number
4 Connection to the X-zone
5 GPS position
6 Email (enabled)
7 SMS (disabled)
8 Cloud (enabled)
key on the main device to open the menu.
.
to activate the group monitoring.
key on the group device to open the menu.
.
key to open the menu.
key on the main device to open the menu.
1
Modbus
xxxxxxxxx
4
5
GPS
6
Dräger X-zone 5500
2
3
7 8
05933112.eps