Milwaukee 3000 Manual Del Operador página 4

SPECIFICATIONS
Cat. No. ...........................................................3000
Vacuum Pump ..................................... 49-50-0200
Gasket Kit ............................................ 43-44-0019
SYMBOLOGY
Read operator's manual
Always wear eye, hearing, and
respirator protection
UL Listing for Canada and U.S.
C US
ASSEMBLY
Assembling Core Drill Stands
1. Set the base on the ground.
2. Raise the mast upright to
the desired angle.
3. Tighten the angle brace
handle securely. If han-
dle cannot turn fully due
to setup orientation, pull
out the handle, rotate
back, push in, tighten
and repeat.
4. Slide carrier assembly
onto the mast, match-
ing carrier wheels with
grooves in the mast.
NOTE: Over time, the
carrier assembly may
become loose and need
to be tightened (see "Ad-
justing Carrier Assem-
bly" in the Maintenance
section)
5. Press in the feed handle
button and insert the
feed handle into one of
the handle locations.
Release the button. En-
sure the handle clicks
into place.
6. Turn the feed handle to
lower or raise the carrier.
When the carrier is fully raised, it can be lifted off
of the mast.
Attaching Wheel Assembly
(Optional)
Knob Screw
1. Set the base on the ground upright.
2. Align holes in wheel base to the back of the stand,
as shown.
3. Insert the bolt through the holes connecting the
wheel assembly to the base and insert cotter pin
through the hole in the end of the bolt.
4. Hand tighten the knob screw in back end of wheel
assembly securely.
Mounting the Core Drill to the Stand
WARNING
fore installing the drill.
Use a MILWAUKEE MX FUEL ™ Core Drill with
this stand.
1. To mount the drill, loosen the mount plate handle.
2. Place core drill, spindle-down, into the mount plate.
Handle
Angle
Brace
3. Hand tighten the mount plate handle. If the core
drill prevents the mount plate handle from fully
rotating, pull out the handle, rotate back, push in,
tighten and repeat.
4. After the core drill is mounted, ensure the carrier
is rigid against the mast. A loose carrier can allow
the drill or bit to wobbling during coring. Wiggle
the drill front to back and side to side. If it moves,
tighten the mount plate. If the drill continues to
feel loose, see "Adjusting Carrier Assembly" in
the Maintenance section for more information.
5. To remove drill, loosen the mount plate handle and
pull the drill away from the stand.
WARNING
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Methods for Securing Equipment to
WARNING
face to help prevent personal injury and to protect
the stand. Do not rely on the weight of the stand,
shoring pin alone or body weight on the stand
for securing during use. An unsecured stand
could rotate during coring and possibly cause
injury. NEVER attempt to use body weight to hold
stand. Never rely on the shoring pin alone for
securing.
4
To reduce the risk of injury, always
unplug drill or remove battery be-
OPERATION
To reduce the risk of injury, always
wear proper eye protection marked
Work Surface
To reduce the risk of injury always
secure the stand to the work sur-