Temperature Selection; Caster Installation; Interior Light; Leveling Instructions - Danby DAR044A6BSLDBO Manual Del Propietário

OPERATING INSTRUCTIONS

TEMPERATURE SELECTION

The temperature of the appliance can be adjusted
by turning the thermostat dial.
The larger dots indicate the coldest setting.
The smaller dots indicate the warmest setting.
The "OFF" position will turn off the cooling function.
Internal temperature of the appliance can vary
based on ambient temperature, the quantity of items
stored and how frequently the door is opened.
Min

INTERIOR LIGHT

If the light bulb burns out, it can be replaced by
following the steps below. Ensure the appliance is
unplugged before replacing the light bulb.
1. Remove the screw from the center of the light
cover and pull the cover downward.
2. Remove the old light bulb and discard. Replace
with a 15 watt light bulb.
3. Replace light cover.

LEVELING INSTRUCTIONS

There is an adjustable foot on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level.
1. Turn the adjustable foot counter-clockwise until
the top of the foot is touching the bottom of the
chassis.
2. Slowly turn the adjustable foot clockwise until the
appliance is level.
OFF
Max

CASTER INSTALLATION

To reduce the risk of personal injury or property
damage, we recommend unplugging the appliance
and using two people to complete the caster
installation.
1. Place the appliance on its back. Protect the fl oor
and the back of the unit from damage by laying
the appliance on a towel or blanket.
2. Remove the three solid feet. Unscrew the
adjustable foot. Keep the solid feet and
adjustable foot for future use.
3. Install the non-locking casters on the back of the
appliance where the mounting holes are already
pre-drilled and threaded.
4. Install the larger locking caster at the front of the
appliance opposite the hinge.
5. Remove the hinge plate installed on the
appliance and replace it with the hinge plate
provided in the caster box.
6. Install the smaller locking caster into the pre-
drilled hole in the caster hinge plate.
7. Once completed, allow the unit to stand upright
for a minimum of 6 hours to avoid damage to
internal components.
1. Solid feet
2. Adjustable foot
3. Adjustable foot hinge plate
4. Non-locking casters
5. Larger locking caster
6. Caster hinge plate
7. Smaller locking caster
1
1
5
4
3
2
1
6
7
4