Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
BULB REPLACEMENT
•
Unplug the AC power cord from the wall.
•
Remove the screw that holds the light bulb cover.
•
Squeeze the tabs at the top and bottom of the light bulb cover
simultaneously.
•
Remove the light bulb cover.
•
Make sure the light bulb is cool before removing.
•
Unscrew the bulb
•
Replace with a 10 watt bulb that is the same shape and size.
•
Replace the light bulb cover.
Operating Instructions
TEMPERATURE SELECTION
The temperature of the refrigerator/freezer can be adjusted by turning the thermostat
dial. The range of temperature controls is from position "OFF," or NO COOLING to "7,"
the coldest. The setting of "4" should be satisfactory for home refrigerator use.
DEFROSTING YOUR APPLIANCE
Defrost the freezer compartment whenever the layer of frost on the surface of the evaporator reaches 1/4" or 6 mm.
When defrosting, remove all food and set the thermostat to the "OFF" or "0" position. Put the drip tray under the evapora-
tor to collect melted water. After the frost has melted, discard the melted water and dry up the interior of the refrigerator.
The refrigerator can be restarted by turning its thermostat to the desired setting
Important: You must remember to close the refrigerator door before the defrost cycle terminates and normal operating
conditions resume automatically. The drip tray should be in position directly below the freezer compartment to catch con-
densed water during defrosting.
Note: Never use sharp or pointed instruments to remove ice from the freezer compartment. The freezer compartment
contains refrigerated gas lines and if accidentally punched/pierced, will render the refrigerator inoperable and void the
manufacturer's warranty. Do not allow the refrigerator to continue operation if the freezer compartment is pierced.
After defrosting is complete, set the control to maximum for 2 to 3 hours before returning to the desired position. When
the refrigerator is not to be used for a long period of time, disconnect the appliance from the electrical supply and leave
the door partially open. This will help reduce mold and mildew build-up.
Note: Wait 3 to 5 minutes before attempting to restart the refrigerator if operation has been interrupted.
5
Publicidad
Tabla de contenido
