Step 6, Install Decorative Duct Covers - GE Monogram ZV850 Instrucciones De Instalación

INSTALLATION – VENTED TO THE OUTSIDE
INSTALL DECORATIVE DUCT COVERS
on the support frame. This will make screw installation
easier.
pattern on one end.
For this vented installation to the outside, the hole
pattern should be located at the bottom.
and push to the ceiling.
the top with 2 supplied duct cover screws.
Installation Instructions
.
14
tighten against the frame to allow the second duct
cover to slide up and pass over.
duct cover and push up past the stop screw location.
bottom duct cover and prevent it from sliding down
onto the top of the hood.
CAUTION:
installed. Failure to do so could result in personal
injury or damage to the duct cover.
The stop screw must be