Power Supply; Tools And Materials Required; Grounding Instructions - GE Monogram ZV850 Instrucciones De Instalación

POWER SUPPLY

IMPORTANT – (Please read carefully)
WARNING:
Remove house fuse or open circuit breaker before
beginning installation.
Do not use an extension cord or adapter plug with
this appliance. Follow National Electrical Code or
prevailing local codes and ordinances.
Electrical supply
This vent hood must be supplied with 120V, 60Hz,
and connected to an individual, properly grounded
branch circuit, and protected by a 15- or 20-amp
circuit breaker or time-delay fuse.
requirements, call a licensed electrician before
proceeding.
location as possible. Route additional length from
ceiling joists to reach the junction box on the
hood.
accordance with local codes.

Grounding instructions

The grounding conductor must be connected to
a ground metal, permanent wiring system, or an
equipment-grounding terminal or lead on the hood.
WARNING:
of the equipment-grounding conductor can result
in a risk of electric shock. Check with a qualified
electrician or service representative if you are in
doubt whether the appliance is properly grounded.
Installation Preparation
The improper connection

TOOLS AND MATERIALS REQUIRED

Pencil and tape measure
Spirit level
Phillips screwdriver
Electric drill with 5/32" bits,
#2 Phillips and 7/16" socket
Stepladder
Aluminized
duct tape
Strain relief for
junction box
6
Safety glasses
Gloves
Hammer
Flashlight
Utility knife
10 mm wrench
Metal snips
Pliers
Masking
Wire cutter/stripper
tape
Saber saw or keyhole saw
6" round metal
duct, length to
Plumb
suit installation
120V, 60Hz. 15- or 20-Amp,
2-wire with ground, properly
grounded branch circuit