Bluetooth; Bluetooth - Connection - Kenwood KMM-BT728HD Manual De Instrucciones

Bluetooth®
• Depending on the Bluetooth version, operating system and the firmware
version of your mobile phone, Bluetooth features may not work with this
unit.
• Be sure to turn on the Bluetooth function of the device to make the
following operations.
• Signal conditions vary depending on the surroundings.
Bluetooth — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Rear panel
Microphone
(supplied)
Microphone
input jack*
Adjust the
microphone angle
* For the location of the microphone input terminal/microphone input jack, refer to page 38.
22
ENGLISH
Pair and connect a Bluetooth device for the first time
Press B SRC to turn on the unit.
1
2 Search and select the name of your receiver ("KMM-BT728HD"/
"KMM-X704"/"KMM-BT328U"/"KMM-BT328"/"KMM-BT260U"/
"KMM-BT228U"/"KMR-M328BT") on the Bluetooth device.
"PAIRING"
KNOB" appears on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3
Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
Once pairing is completed, Bluetooth connection is established
automatically.
•
"BT1" and/or "BT2" indicator on the faceplate lights up.
" " indicator lights up to show the strength of the battery and signal of
the connected device.
•
window lights up.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
[DEVICE DELETE] on page 26.
Secure using cord
• A maximum of two Bluetooth phones and one Bluetooth audio device can
clamps (not supplied)
be connected at any time. To connect or disconnect the registered device,
if necessary.
see [PHONE SELECT] or [AUDIO SELECT] in [BT MODE]. (Page 26)
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page 27)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more
information.
"PASS XXXXXX" "Device name"
/ / /
/ : "BT1" and/or "BT2" indicator on the display
"PRESS" "VOLUME
/ :