Saving, Resetting And Restoring Settings; Save Contractor Default Settings; Reset Contractor Default Settings; Restore Contractor Default Settings - Rain Bird WR2 Serie Manual Del Usuario

Ocultar thumbs Ver también para WR2 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Saving, Resetting
and Restoring
Settings
Save Contractor Default
Settings
Reset Contractor Default
Settings
The Contractor default setting stores
programming details related to rainfall and
temperature set points.
Reset and save programming details in
accordance with Section
Reset Contractor Default
Settings
If this programming is inadvertently changed,
it is simple to restore.
WR2 user manual (637469-01) EN ESMX FRCA.indd 7
Once the Controller
Interface is completely
+
programmed, press
and right arrow buttons
simultaneously for five
(5) seconds to save
contractor default setting.
All programmed icons will
flash in unison one time to
indicate program is saved.
and
.
+
Press
and
buttons
simultaneously for five
(5) seconds, or until the
screen goes blank. When
icons reappear, contractor
default settings are
restored.
WR2 Wireless Sensor • www.rainbird.com/WR2

Restore Standard Setting

Press the
buttons simultaneously
for five (5) seconds, or
until the screen goes
blank, to cancel the
Contractor default setting
and restore the "Standard
Setting": temperature
37°F (3°C), rain fall ¼"
(6mm) and "programmed
irrigation" mode. When
icons reappear, "Standard
Setting" is active.
Select the Sensor
Location
The communication range for the
WR2 Wireless Sensor is 700 feet
(213.4 meters).
A blinking light on the bottom of the
Sensor indicates signal strength for 20
minutes immediately following successful
pairing. The Sensor updates its signal
strength every 3 seconds (i.e. 1 blink =
reliable signal strength, series of 4 blinks
= strongest signal strength). If the signal
strength is not optimum in one location,
try another location. Even as little as a few
feet difference in placement can improve
signal strength.
Signal
GOOD
Install
POOR
DO NOT install
Select a mounting location where the rain
sensor will receive direct rainfall. Make
sure the sensor extends beyond the roof
line, tree limbs and any other obstructions.
Install the Rain Sensor in an area that
receives as much rain and sunlight as the
landscape. Be sure to mount the sensor
above spray from the sprinklers.
and left arrow
Sensor LED
1-4 Blinks
Does not blink
7
2/23/2018 8:09:25 AM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wr2-48 serieWr2

Tabla de contenido