8
PHONES jack
When you listen with headphones, connect the
headphones to the PHONES jack and set both
SPEAKERS A and B switches to the OFF position.
9
SPEAKERS
Press the switch A or B (or both) inward (ON) for the
speakers you will use. Press and release the switch
outward (OFF) for the speakers you do not use.
0
Tone controls
BASS
Rotate this knob to increase or decrease the low
frequency response. The 0 position produces a flat
response.
TREBLE
Rotate this knob to increase or decrease the high
frequency response. The 0 position produces a flat
response.
PHONES
PHONES
A
BALANCE
The balance of the output volume to the left and right
speakers can be adjusted to compensate for sound
imbalances caused by the speaker location or listening
room conditions.
B
LOUDNESS
Used to compensate for the human ears' loss of
sensitivity to high and low-frequency ranges at low
volume. (Refer to page 12 for details.)
C
REC OUT selector
Rotate this knob to select the source for recording to
an MD recorder or tape deck. This setting is
independent of the INPUT selector setting, so this
function allows you to record the selected source while
listening to another source.
D
Front cover
Refer to inside of the front cover on how to open and
close the front cover.
E
INPUT selector
Turn this knob to select the input source.
The selected source will be shown by the lighting of
corresponding input source indicator.
F
VOLUME
Turn this knob to raise or lower the volume level. (The
REC OUT level is not affected.)
5
E-