Yamaha CDX-596 Manual De Instrucciones página 3

CAUTION: Read this before operating your unit.
● To assure the finest performance, please read this
manual carefully. Keep it in a safe place for future
reference.
● Install your unit in a well ventilated, cool, dry, clean place
— away from windows, heat sources, vibration, dust,
moisture, or cold. To avoid humming sounds, locate the
unit away from other electrical appliances, motors, and
transformers. To prevent fire or electrical shock, do not
expose to rain and water.
● Be sure to allow at least 10 cm of ventilation space at the
top, on left, right, and back sides of this unit.
● Do not operate the unit upside-down. It may overheat,
possibly causing damage.
● Never open the cabinet. If something drops into the set,
contact your dealer.
● Do not use force on switches, knobs or cords.
● When not planning to use this unit for long periods of time
(i.e., vacation, etc.), disconnect the AC power plug from
the wall outlet.
● Grounding or polarization — Precautions should be taken
so that the grounding or polarization of the unit is not
defeated.
● Do not clean the unit with chemical solvents; this might
damage the finish. Use a clean, dry cloth.
● Be sure to read the "Troubleshooting" section on common
operating errors before concluding that your unit is faulty.
● Do not place another component on top of this unit, as
damage or discoloration on the surface of the unit may
result.
● To prevent damage by lightning, disconnect the power
cord from the wall outlet during an electrical storm.
● When disconnecting the power cord from the wall outlet,
grasp the plug; do not pull the cord.
● Do not plug the AC power plug to the wall outlet before
you finish all connections.
● The voltage to be used must be the same as that
specified on this unit. Using this unit with a higher voltage
than that which is specified is dangerous and may result
in a fire or other type of accident causing damage.
YAMAHA will not be held responsible for any damage
resulting from use of this unit with a voltage other than
that which is specified.
● Sudden temperature changes and storage or operation in
an extremely humid environment may cause
condensation inside the cabinet.
CAUTION FOR MOVING THE UNIT
Before moving the unit, first remove the disc from the
unit, press POWER to turn the unit off, and then
disconnect the AC power plug from the wall outlet.
CAUTION
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
Laser component in this product is capable of emitting
radiation exceeding the limit for Class 1.
SPECIAL INSTRUCTIONS FOR U.K. MODEL
IMPORTANT:
The wires in the mains lead are coloured in accordance
with the following code:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows: The wire which is coloured BLUE must be
connected to the terminal which is marked with the letter
N or coloured BLACK. The wire which is coloured
BROWN must be connected to the terminal which is
marked with the letter L or coloured RED. Making sure
that neither core is connected to the earth terminal of the
three pin plug.
For U.K. customers
If the socket outlets in the home are not suitable for the plug
supplied with this appliance, it should be cut off and an
appropriate 3 pin plug fitted. For details, refer to the
instructions described above.
Note: The plug severed from the mains lead must be
destroyed, as a plug with bared flexible cord is hazardous if
engaged in a live socket outlet.
This compact disc player is
classified as a CLASS 1
LASER product.
The CLASS 1 LASER
PRODUCT label is located
on the rear exterior.
E-
1