Changing Brightness Of The Display; Automatic Spacing - Yamaha CDX-596 Manual De Instrucciones

Changing brightness of the display

CDX-596
You can change the brightness of the display (or turn off the illumination) by pressing DIMMER.
During play
Normal illumination
Dim
(off)*
* While the display illumination is off,
the AUTO DISPLAY OFF indicator
on the front panel lights up.
CDX-496, CDX-396
If desired, you can change brightness of the display
in three degrees by pressing DIMMER.

Automatic spacing

If you record a disc onto tape with an insufficient time space
between tracks, the tape deck will not be able to perform
blank search operations on the tape correctly. To prevent
such a search mistake of the deck, press SPACE and light
up "SPACE" on the display before recording. Spaces of
about 4 seconds are inserted between the tracks.
SPACE
Adjusting the level of signals output to the amplifier and the headphone listening level
CDX-596 and CDX-496 only
You can adjust the level of signals output to the amplifier by
pressing – OUTPUT LEVEL +.
12
E-
AUTO
DISPLAY OFF
SPACE
– +
OUTPUT LEVEL
During a stop or a pause
Normal illumination
DIMMER
Dim
Dim*
* The AUTO DISPLAY OFF indicator lights up.
If a disc is played in this state, the display
illumination will be turned off.
DIMMER
Note
When the automatic spacing function is in effect, the display
of the total time and of the total remaining time will include
each of the 4 second intervals placed between tracks.
To cancel the automatic spacing function
Press SPACE.
SPACE
When you listen with headphones,
connect the headphones to the
PHONES jack and adjust the
volume by pressing – OUTPUT
LEVEL +. At that time, note that
this adjustment will also vary the
signal level output to the amplifier.
Normal illumination
Slightly dim
Dim
"SPACE" disappears
from the display.
PHONES
PHONES