Cuisinart SS-10 Manual De Instrucciones página 10

Ocultar thumbs Ver también para SS-10:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Caution: There are two sharp
needles that puncture the
capsule, one above and one
below. To avoid risk of injury,
do not put your fingers in the
capsule brewing chamber.
6. Lower the handle to close the brew
head. When closed completely,
the control panel will indicate READY
(see figure 7). All brew-size icons will be
displayed with the default size shown as
a solid mug. To choose a different size,
use the
or
buttons. Choose from
4-oz., 6-oz., 8-oz., 10-oz., and 12-oz.
brew sizes.
Note: The 8-oz. serving is the factory-
set default brew size. To program your
favorite brew size, see Programming
Your Brew Size on page 16.
Ready Mode
figure 7
7. Once a size is chosen, press Brew.
Only the Brew button will be lit.
The control panel will now display
BREWING, as well as the serving size
you selected (see figure 8).
figure 8
Note: There may be a short pause
before the brewing process begins.
The entire brew process lasts
approximately 1–2 minutes, depending
on brew size selected, and ends with
a burst of air to remove all liquid from
the capsule.
Caution: There is very hot water in
the capsule chamber during the
brew process. To avoid risk of injury,
do not lift the handle or open the
capsule chamber during the brew
process.
8. Lift the handle, then remove and
dispose of the used capsule. Close the
brewing head.
Caution: Capsule will be hot.
Following the brew, your coffeemaker will
immediately be ready for your next brew.
Enjoy your cup of gourmet
coffee, tea, or hot cocoa!
Note: If not used within 60 seconds, the
unit will return to Idle mode and OPEN HEAD
will be displayed on the control panel.
To restart the process, open and close
the handle and control panel will display
READY again.
10

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido