Stopping The Brew Process; Adding Water; Programming; Setting The Clock - Cuisinart SS-10 Manual De Instrucciones

Stopping the Brew
Process
If for any reason you need to stop brewing
after the process has started, press the
BREW button, OR press the power switch
on the rear right side of the coffeemaker to
turn the coffeemaker off. The flow of coffee,
tea or hot cocoa will stop, the heater will
shut off, and the blue lights illuminating the
control panel will turn off.
Note: You may get less coffee, tea or hot
cocoa in your cup during your next brew.
In order for your next brew to be the volume
you have selected, we recommend that you
perform a rinse cycle after a terminated brew.

Adding Water

The control panel will indicate when the
water level in your reservoir is low or if the
reservoir has been removed by displaying
the words "ADD WATER." When "ADD
WATER" is displayed, the coffeemaker will
not allow you to brew.
The Water Reservoir can be filled in
two ways:
1. Lift off the reservoir lid and pour water
directly into the reservoir while it is still
attached to the coffeemaker, then
replace the lid.
2. Remove the reservoir from coffeemaker
by first removing the lid from the reservoir,
then lifting the reservoir straight up and
away from the coffeemaker. Fill with
water, place the reservoir back on the
coffeemaker, and replace the lid.
IMPORTANT: Do not remove the water
reservoir during the brewing process.
Note: If your coffeemaker has not been
used for more than one week, we suggest
running a rinse cycle before next brew.

Programming

Setting the Clock

Setting the clock is optional. When the clock
is set, the time will appear on the control
panel. Note: You must set the clock if you
plan on using the ON OFF TIME SET
programming feature.
1. Press the Menu button. Programming
options will appear on the control panel
with CLOCK flashing. The word OFF will
appear at the top of the control panel
to indicate that the clock is not set
(see figure 14).
2. Press or hold the
through the hours until you have
reached the appropriate hour. Be sure
the PM indicator is on if a PM time is
desired.
3. Press or hold the
through the minutes until you have
reached the desired minutes.
4. When you have reached the correct
time, press the Menu button to set the
time. Continue pressing Menu to scroll
through the remaining programming
functions to exit the Programming mode.
5. The correct time should now be
displayed on top of the control panel
(see figure 15).
13
Set Minutes
Set Hours
figure 14
button to scroll
button to scroll