Maxon C2 Manual De Instrucciones página 6

1. Measure the truck truck body (FIG. 6-1).
• Overall width
• Door opening
• Maximum bed height (truck unloaded)
2. Compare measurements with the dimen-
sions for your liftgate shown on Sheets 3
and 4.
3. Remove Liftgate installation kit shipped with
Liftgate (Sheet 1). Then, verify the correct
parts were shipped with liftgate.
NOTE: Select the bolt holes, under main
frame housing, that put the angles in
best position for mounting to frame
rails on the truck.
4. Bolt the shipping angles (Kit items), to the
bottom of the main frame housing (FIG.
6-2). Use the 1/2"-13 x 1" long bolts (Kit
items) with mounting holes on the bottom
of the main frame houing. Put the angles
in best position for mounting on the truck
frame rails.
LIFT CORPORATION Sht. 6 of 36 DSG#
PREPARING LIFTGATE
M-14-34
RH COLUMN
SHIPPING ANGLE
(2 PLACES)
BOLT, WASHER & NUT
BOLTING ANGLES TO BOTTOM
OF MAIN FRAME
FIG. 6-2
Rev. A Date: 03/03/17
OVERALL
BODY WIDTH
DOOR
OPENING
MAX. BED
HEIGHT
FIG. 6-1
LH COLUMN
ANGLE
(2 PLACES)
(2 PLACES)