Yamaha RX-SL100RDS Manual De Instrucciones página 52

EDITING SOUND FIELD PARAMETERS
3
Press k/n repeatedly to access the sound
field program parameters.
4
Press l / h repeatedly to adjust the sound
field parameter.
5
To change parameter values for a different
sound field, repeat steps 2 through 4.
Note
You cannot change parameter values when Memory Guard is set
to "ON". If you want to change the parameter values, set Memory
Guard to "OFF" (see page 45).
DSP LEVEL (DSP level)
Function: This parameter adjusts the level of all the
DSP effect sounds within a narrow
range.
Description: Depending on the acoustics of you
listening room, you may want to increase
or decrease the DSP effect level relative
to the level of the direct sound.
Control range: –6 dB – +3 dB
DELAY (Delay)
Function: This parameter changes the apparent
distance from the source sound by
adjusting the delay between the direct
sound and the first reflection heard by
the listener.
Description: The smaller the value, the closer the
sound source seems to the listener. The
larger the value, the farther it seems. For
a small room, set to a small value. For a
large room, set to a large value.
Control range: 1 – 99 msec
50
ENTER
ENTER
For 6ch Stereo
Function: These parameter adjusts the volume level
for each channel in 6-channel stereo
mode.
Control Range: 0 – 100%
CT LEVEL (Center level)
SL LEVEL (Surround left level)
SR LEVEL (Surround right level)
SB LEVEL (Surround back level)
For PRO LOGIC II Music
PANORAMA (Panorama)
Function: Extends the front stereo image to include
the surround speakers for wraparound
effect.
Choices: OFF/ON, initial setting is OFF.
DIMENSION (Dimension)
Function: Gradually adjusts the sound field either
towards the front or towards the rear.
Control range: –3 (towards the rear) to +3 (towards the
front), initial setting is STD (standard).
CT WIDTH (Center width)
Function: Adjusts the center image from all three
front speakers to varying degrees. A
larger value adjusts the center image
towards the front left and right speakers.
Control range: 0 (center channel sound is output only
from center speaker) to 7 (center channel
sound is output only from front left and
right speakers), initial setting is 3.
For PRO LOGIC II Music, Movie and Game
PLII/PLIIx (Pro Logic II/Pro Logic IIx)
Function: Switches the type of Pro Logic decoding
to be used. PLII decoding creates 5.1-
channel sound from 2-channel sources.
PLIIx decoding creates 6.1-channel
sound from 2-channel sources.
Choices: PLII, PLIIx
For DTS Neo:6 Music
C. IMAGE (Center image)
Function: This parameter adjusts the center image
from all three front speakers to varying
degrees.
Control range: 0 – 0.5