Setting Up For Hands-Free Phoning; Making A Phone Call - Pioneer DEH-P7200HD Manual De Instrucciones

Section
03 Available accessories
Shows when an incoming call has been re-
ceived and not checked yet.
! Incoming call notice is not displayed for
calls made when your cellular phone is
disconnected from this unit.
Important
! Since this unit is on standby to connect with
your cellular phone via Bluetooth wireless
technology, using this unit without running
the engine can result in battery drainage.
! Operations may vary depending on the kind of
cellular phone.
! Advanced operations that require your atten-
tion such as dialing numbers on the monitor,
using phone book, etc., are prohibited while
you are driving. When you need to use these
advanced operations, stop your vehicle in a
safe place.
Notes
! The equalizer curve for the phone source is
fixed.
! When selecting the phone source, you can
only operate Fader/Balance (balance adjust-
ment) in the audio menu.

Setting up for hands-free phoning

Before you can use the hands-free phoning
function you must set up the unit for use with
your cellular phone. This entails establishing a
Bluetooth wireless connection between this
unit and your phone, registering your phone
with this unit, and adjusting the volume level.
22
En
1 Connection
For detailed instructions on connecting your
phone to this unit via Bluetooth wireless technol-
ogy, see following section. Function and operation
on the next page.
! To make best use of the technology, we re-
commend you register the phone to this unit.
2 Registration
To register your temporarily connected phone,
refer to Set phone (registereing a connected cellu-
lar phone) on page 24.
3 Volume adjustment
Adjust the earpiece volume on your cellular
phone for comfort. When adjusted, the volume
level is recorded in this unit as the default setting.
! Caller's voice volume and ring volume may
vary depending on the type of cellular phone.
! If the difference between the ring volume and
caller's voice volume is big, overall volume
level may become unstable.
! Before disconnecting the cellular phone from
this unit, make sure to adjust the volume to a
proper level. If the volume is muted (zero
level) on your cellular phone, the volume level
of your cellular phone remains muted even
after the cellular phone is disconnected.

Making a phone call

Voice recognition
1 Press BAND/ESC and hold until Voice dial ap-
pears in the display.
Voice dial appears in the display. When Voice
dial ON is displayed, voice recognition function is
now ready.
! If your cellular phone does not feature voice
recognition function, No voice dial appears
in the display and operation is not possible.
2 Pronounce the name of your contact.