Ferm MSM1037 Manual De Uso página 11

cloth dampened with soapy water. Never use
solvents such as benzene, alcohol, ammonia, etc.
These types of solvents can damage the plastic
parts.
Problem solving
1. The motor does not start
• The plug is not in the socket.
• The power cord is broken.
• The switch is defective. Take the machine
to your dealer for repair.
2. The saw cut is not even (jagged)
• The saw blade must be sharpened.
• The saw blade is mounted back to front.
• The saw blade is clogged with resin or
sawdust.
• The saw blade is not suitable for the piece
of work being used.
3. The height and/or mitre lever is obstructed
• Chips and/or dust must be removed.
4. The motor has difficulty in reaching full
speed
• The extension cord is too thin and/or too
long.
• The mains voltage is less than 230 V.
5. The machine vibrates excessively
• The saw blade is damaged.
6. The machine becomes excessively hot
• The ventilation slots are blocked. Clean
them out with a dry cloth.
7. The electromotor runs unevenly
• The carbon brushes are worn out. Replace
the carbon brushes or consult your dealer.
Lubrication
The machine does not need any extra lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
WARRANTY
The warranty conditions can be found on the
separately enclosed warranty card.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.
11