Stopping; Stop The Engine - Husqvarna FS 3500 G Manual De Instrucciones

Stopping

WARNING! Always keep all parts of your
body away from blade and all other moving
parts.
Stop the cutting
• Put Forward/Reverse control lever into the Stop/Neutral
position.
• Raise the diamond blade out of the cut by pressing the
Raise/lower switch on the control lever upward until the
diamond blade clears the surfaces.

Stop the engine

1 Turn the Engine throttle knob to the low idle position.
2 Turn the Water valve off.
3 Let the engine run at idle for a few minutes before shutting
off. Do this within the cutting area and do not leave the
machine unsupervised.
4 Stop the engine by turning the Engine start switch to the
STOP position.
1
3
24 –
English
STARTING AND STOPPING
2
4