Starting And Stopping - Husqvarna WB48S Manual De Instrucciones

Starting and stopping

WARNING! Note the following before
!
starting:
Do not start a lawn mower unless the cutter
and all covers are fitted correctly. Otherwise
the cutter could come loose and cause
personal injuries.
Always move the machine away from the
refuelling area before starting.
Place the machine on a flat surface. Ensure
the cutting attachment cannot come into
contact with any object.
Keep people and animals well away from the
working area.
Cold engine
Ensure the ignition lead sits correctly on the spark plug.
Starting: Open the fuel tap.
Choke: Set the throttle control in the choke position.
Warm engine
Use the same starting procedure as for a cold engine, but do
not set the throttle control in the choke position.
Starting
Pull the engine brake handle against the upper handlebar
with your left hand.
Grip the starter handle, slowly pull out the cord with your right
hand until you feel some resistance (the starter pawls grip),
now quickly and powerfully pull the cord.
Never twist the starter cord around your hand.
CAUTION! Do not pull the starter cord all the way out and do
not let go of the starter handle when the cord is fully extended.
This can damage the machine.
12 –
English
STARTING AND STOPPING
Drive
To engage the drive, push the clutch lever forwards.
Stopping
• Stop the engine by releasing the engine brake handle.
The drive is also disengaged when you release the brake
handle Only the drive can be disengaged by releasing the
brake lever a bit.
• Close the fuel tap.