Bosch TASSIMO VIVY TAS 12EU Serie Instrucciones De Uso página 12

h
Troubleshooting
Problem
The appliance does not
recognise the inserted
T DISC and remains
in energy-saving mode
(dimmed, lighting Status
LED 3) or Status LED 3
lights up red.
The brewing unit cannot
be securely closed.
The brewing unit cannot
be opened.
Fill water tank 2
lights up.
Fill water tank 2 lights
up even though there
is enough water in the
water tank.
Descale 1 lights up or
starts flashing.
Descale 1 lights up
or starts flashing even
though decalcified water
has been used.
en 10 10
TAS12xx_1Text_EU.indb 10
Cause
No T DISC inserted.
The appliance does not
recognise the bar code.
The brewing unit is not
closed properly.
The piercing unit or the
T DISC support has not
been correctly inserted.
The T DISC has not been
correctly inserted.
The brewing unit is not
closed properly.
The brewing unit is still
locked.
There is not enough water in
the water tank.
The float in the water tank
is stuck.
The water tank is not
inserted correctly.
The appliance needs to be
descaled.
Even decalcified water
contains low amounts of
calcium carbonate.
Solution
Check that a T DISC has been inserted.
Clean the T DISC reading window with a
soft, damp cloth.
Smooth out the foil of the T DISC with your
finger so that the bar code can be read.
Use a new T DISC.
If the problem persists, contact the
T ASSIMO careline.
Clean the brewing unit with a soft, damp
cloth, paying particular attention to the lid
area.
Press the piercing unit into its holder using
both thumbs (until an audible click is
heard).
Reinsert the selected T DISC. Make sure
that it is placed in the T DISC support with
the printed side facing downwards. Place
the tab of the T DISC in the slot.
Clean the brewing unit with a soft, damp
cloth, paying particular attention to the lid
area.
Press the lid down until it audibly clicks
into place.
Wait until the Status LED 3 has stopped
blinking before attempting to open the
b rewing unit.
If the brewing unit stays locked, contact the
T ASSIMO careline.
Fill the tank with cold, fresh water as far as
the max mark. Reinsert the water tank.
Clean the water tank and free the float.
Check that the water tank has been
c orrectly inserted.
Descale the appliance. Please refer here to
the section f Descaling.
Descale the appliance. Please refer here to
the section f Descaling.
19.03.2013 14:52:24