Electrical Connection - Bosch 300 Serie Instrucciones De Uso

Prior to installation
The two lightly sprung flaps must be
able to move upwards
If the exhaust air is going to be
discharged into the open, a telescopic
wall box should be fitted into the outside
wall.
For optimum hood efficiency:
Short, smooth air exhaust duct.
As few bends in the duct run as
possible.
Diameter of duct to be as large as
possible and no tight bends in duct run.
Round pipes:
We recommend
Internal diameter: 6".
Flat ducts must have an internal cross-
section that equates to that of round
pipes.
There should be no sharp bends.
minimum 3 1 / " x 10" recommended.
4
If pipes have different diameters:
Insert appropriate transition pieces.
Always ensure that there is an adequa-
te supply of fresh air.
Connecting a l 6" exhaust-air pipe:
Mount the pipe directly onto the air
outlet on the hood.
Preparing the wall
The wall must be flat and perpendicular.
Ensure that the wall is capable of
providing a firm hold for mounting
screws and plugs.
Weight in lbs:
30"
36"
We reserve the right to change specifications or design
without prior notice.
28
31

Electrical connection

WARNING: THIS APPLIANCE MUST BE
CONNECTED TO GROUND
IMPORTANT: Fitting a Different Plug:
The wires in the power lead are coloured in
accordance with the following code:
Green
White
Black
If you fit your own plug, the colours of
these wires may not correspond with the
identifying marks on the plug terminals.
This is what you have to do:
1. Connect the green (Ground) wire to the
terminal in the plug marked 'E' or with
the symbol ( ).
2. Connect the white (Neutral) wire to the
terminal in the plug marked 'N'.
3. Connect the black (Live) wire to the
terminal marked 'L'.
The hood should only be connected to an
earthed socket that has been installed
according to relevant
regulations.
If possible, site the earthed socket directly
behind the chimney panelling.
Electrical data:
Are to be found on the name plate inside
the appliance after removal of the filter
frame.
Before undertaking any repairs,
always disconnect the hood from the
electricity supply.
Length of the connecting cable: 4 ft.
If it is necessary to wire the hood
directly into the mains:
The hood should only be connected to the
electricity supply by a properly qualified
electrician.
A separator must be installed in the house-
hold circuit. A suitable separator is a switch
that has a contact gap of more than 3 mm
and interrupts all poles. Such devices inclu-
de circuit breakers and contactors.
If the connecting cable for this
appliance is damaged, the cable must be
replaced by the manufacturer or his
customer service or a similarly qualified
person in order to prevent serious injury to
the user.
– Ground
– Neutral
– Live
9