Velleman VMM501 Manual Del Usuario página 21

1. Drag and drop the code blocks to form the code as shown.
You can find the
Drawer. You can find the
Code Drawer.
2. Set P0 to P1 and set the value to 0.
3. Set the
4. Set P0 to P1. Also, set the value 0 to 180.
5. Set the
6. When complete, we compile the programme and generate a hex. file. Click
on the download button and save the hex. file to the Downloads folder 
C:\downloads. This hex. file is ready to upload to the micro:bit.
Plug the micro:bit into a USB port. The, drag and drop the hex. file onto the
micro:bit removable device to upload the programme.
We can see the servo rotating from 0 to 180 degrees. Now, how would you make a dial thermometer with a
temperature sensor and servo?
5.9 Buzzer
1x micro:bit board
1x micro:bit breadboard adapter
1x breadboard
1x mini speaker
1x N-channel MOSFET
1x 100 Ω resistor (brown/black/brown/gold)
We are going to drive a buzzer.
Place the necessary components on the breadboard as shown.
V. 01 – 17/01/2019
VMM501
servo write pin
forever
pause to 2000 ms.
pause to 2000 ms.
21
P0 to 180 block in Pins
and pause (ms) 100 in
in the Code
Basic in the
©Velleman nv