Velleman VMM501 Manual Del Usuario página 7

Testing on micro:bit
Connect the micro;bit to your computer using a micro-USB cable.
It will go through a default sequence, asking you to press buttons and play a game. Try it out!
Click Download to translate your script to a
If you set Chrome up properly, you will not need this next step. Drag the downloaded hex file to the micro:bit
drive, or right-click and
You have just programmed your very own device!
Have a look at the code below.
1. Drag and drop the code blocks to form the code as shown.
You can find the
the Code Drawer. You can find the
in the Code Drawer.
2. Set value for P0 to 0. LED0 off = low voltage = 0 V = digital 0. Set value
for P1 to 1. LED1 on = high voltage = 5 V = digital 1.
3. Set the
4. Set value for P0 to 1. LED0 on = high voltage = 5 V = digital 1. Set value
for P1 to 0. LED1 off = low voltage = 0 V = digital 0.
5. Set the
6. When complete, we compile the programme and generate a hex. file. Click
on the download button and save the hex. file to the Downloads folder 
C:\downloads. This hex. file is ready to upload to the micro:bit.
Plug the micro:bit into a USB port. The, drag and drop the hex. file onto the
micro:bit removable device to upload the programme.
You will see the two LEDs flash alternatively. Now, why not make an RGB traffic light?
V. 01 – 17/01/2019
hex file
Send To in Windows ® .
digital write pin
pause to 500 ms.
pause to 500 ms.
VMM501
and to download it.
P0 to 0 block in
forever and pause (ms)
7
Advanced Pins in

100 in Basic
©Velleman nv