Velleman VMM501 Manual Del Usuario página 8

5.2 Button
1x micro:bit board
1x micro:bit breadboard adapter
1x breadboard
2x red LED (polarisation: anode (+) = long leg,
cathode (-) = short leg)
2x 100 Ω resistor (brown/black/brown/gold)
1x momentary push button
We use a button to control the LED flash. Press the button to
make the LED flash in turns. Release to switch off the LED.
Place the necessary components on the breadboard as shown.
Have a look at the code below.
1. Drag and drop the code blocks to form the code as shown.
You can find the
in
pause (ms)
and
Drag the
The two blocks will snap together.
Drag the
equal function
V. 01 – 17/01/2019
digital read pin
Advanced Pins in the Code Drawer. You can find the

100 in Basic
logic equal function
logic equal function
digital read pin
block as shown.
VMM501
P0 and digital write pin
in the Code Drawer. You can find the
blocks in Logic in the Code Drawer.
block and drop it over the
P0 block and drop it over the 0 of the
8
P0 to 0 blocks
forever and
if then
true block.
logic
©Velleman nv