Lorex Baby LB2251AC1 Guia De Inicio Rapido

ADD-ON CAMERA
LB2251AC1
QUICK START GUIDE
What's Included
x1 x2
Getting Started
Connect the power adapter to the camera and
1
then to a power outlet.
Make sure all power cables are at least 3ft / 1m
away from the crib and out of reach of your child.
Pairing the Camera with Your Monitor
Place the camera and monitor next to each other. Make sure the
1
camera and monitor are turned on.
2
LINK
C1 
3
LINK
C2
NOTE: If a camera is already connected to this channel, the new
camera will replace the existing camera.
www.lorexbaby.com
1-20022013
x1 x2 x2
NOTE:
This camera is wall mountable
and can be powered by batteries (4x
AAA -- not included) see the User's Guide
provided with LB2251 for details.
Slide the power switch Use the included cable clips to help keep
TIP
2
to ON. power cords away from your child.
4
LINK
Press and hold
until is shown on
the monitor.
5
Press to to select the PAIR
channel you would like to
pair the camera to.
NOTE:
Immediately move the camera away from the
monitor to avoid speaker feedback.
NOTE: If pairing was unsuccessful, repeat steps 2 to 5
of the pairing process.
LB2251AC1_Quick Start Guide_R1
Cable clips
Press to confirm
the pairing channel.
The Link LED will
begin flashing.
Press the PAIR button on the
back of the camera.
Page 1