Lorex Baby BB2411AC1 Guia De Inicio Rapido

ADD-ON CAMERA
BB2411AC1
QUICK START GUIDE
What's Included
x1 x2
Getting Started
Connect the power adapter to the camera and
1
then to a power outlet.
Make sure all power cables are
at least 3ft / 1m away from the
crib and out of reach of your child.
Pairing the Camera with Your Monitor
Place the camera and monitor next to each other. Make sure the
1
camera and monitor are turned on.
2 Press and hold on your monitor until the screen looks like the
figure below.
Press to select the channel you would like to pair the camera to.
3
NOTE: If a camera is already connected to this channel, the new
camera will replace the existing camera.
www.lorexbaby.com
1-20022013
x2 x2
x1 NOTE:
and can be powered by batteries
(4x AAA - not included). Please see the
User's Guide provided with BB2411 for
details.
Slide the power switch
TIP
2
to ON.
Press on your monitor to begin pairing. The LINK LED
4
flashes to show that pairing mode is on.
Press the PAIR button on the back of the camera. Video
5
from the camera is immediately shown on the monitor
once the camera has been successfully paired.
C1 
NOTE: Immediately move the camera away from the monitor
to avoid speaker feedback.
BB2241AC1_Quick Start Guide_R1
This camera is wall mountable
Use the included cable clips to help keep
power cords away from your child.
Cable clips
PAIR
Page 1