Changing Temperature Scale Between Celsius And Fahrenheit; Memory Recall - HoMedics Deluxe One-Second Manual Del Usuario

CHANGING TEMPERATURE SCALE BETWEEN
CELSIUS AND FAHRENHEIT
To switch between Celsius and Fahrenheit readings,
press and hold the "Scan" button while the unit is on and
immediately press the "MEMORY" button to toggle
between scales. Once the desired scale is selected,
press the "Scan" button to take a new reading or allow
the unit to turn off automatically and then turn it back on
to view the memory.
USING NIGHT MODE & DAY MODE
Night Mode is a unique feature that allows a temperature
reading to be taken in a dark setting.
Night Mode functions like Day Mode with the addition of
an LED flashlight feature to aid in guiding the probe into
the ear canal and a display that will illuminate for 5
seconds after measurement.
Press and release the
Mode.
Day Mode is recommended for general use in order to
preserve battery life. Modes can be changed at any time
before or after measurement. Do not change modes
during measurement as the accuracy of the reading may
be affected.
to select Night Mode or Day
10

MEMORY RECALL

This thermometer will automatically store the last 20
measurements in memory. The most recent reading will
automatically display when the unit is turned on. Each new
temperature reading will also be entered into the memory
as the most recent record.
When in memory mode, an arrow on the right will appear
with the memory record number as shown below (Fig. 6).
Figure 6
Press "MEMORY" to cycle through the records from
number 1 (the most recent reading) to number 20.
Note that when memory is at capacity, the oldest record
will be deleted to make room for a new reading.
Memory will be cleared as a result of battery removal or
power failure. A default reading of 00 will be displayed
when memory is cleared until a new temperature reading is
taken.
Indicates
memory mode
and number
11