Memory Recall; Changing Temperature Scale Between Celsius And Fahrenheit - HoMedics THERA P TE-100 Manual De Instrucciones

Note that the thermometer will display a default temperature of
00.0˚F/00.0˚C after battery power is restored and until a
measurement is taken.
When the low battery symbol appears on the display (Figure 3),
the battery should be replaced. When the low battery symbol
appears with the "Lo" symbol, the battery must be replaced in
order for the ear thermometer to function.
Figure 3
NOTE: Do not discard used lithium batteries in trash. Please
turn in at an official collection point. If the monitor will not be
used for an extended period of time (three months or more),
please remove battery.
CHANGING TEMPERATURE SCALE BETWEEN
CELSIUS AND FAHRENHEIT
To switch between Celsius and Fahrenheit readings,
simply press and release the "°F/°C" button located behind the
battery compartment cover while the unit is on by using a small
flat instrument. Once the desired scale is selected, press the
"Scan" button to take a new reading or allow the unit to turn off
automatically and then turn it back on to view the converted
temperature stored in memory.
Low battery
warning
8

MEMORY RECALL

This thermometer will automatically store the last temperature
measurement in memory. The most recent reading will
automatically display when the unit is turned on. Each new
temperature reading will replace the temperature stored in the
memory.
When viewing a memory reading, the symbol below will appear
in the bottom left corner of the display.
Indicates
a memory
reading
HOW TO TAKE A TEMPERATURE READING
1. Always make sure that the waterproof probe has been
cleaned with a cotton swab moistened with alcohol since its
previous usage.
c c
9