Installation Checklist; Getting Started; Water Filter Installation - KitchenAid W10815169A Manual Del Usuario

Refrigerador de dos puertas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fingerprint-Resistant Steel and Black Stainless Steel
(on some models)
A specialized coating for stainless steel that resists smudges,
fingerprints, and water marks. It is easy to clean with just water
and a towel.
LED Lighting
There is bright LED strip lighting for maximum illumination.
LED lights do not require replacement.
Door Alarm
A helpful alarm sounds when the refrigerator door or freezer
drawer is left ajar.

INSTALLATION CHECKLIST

✔ Electrical Power
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug refrigerator into a grounded 3 prong outlet.
✔ Doors
If doors need to be removed during installation, see the
"Remove and Replace Doors" section in the instructions.
Check that handles are secure and installed according to the
instructions.
Doors seal completely.
Refrigerator is level. (Remove base grille and adjust leveling
feet so they are snug against the floor.)
Doors are even across the top. (Use door alignment feature if
necessary.)
Base grille is properly attached to the refrigerator.
✔ Ice and Water System (on some models)
Connect refrigerator to a cold water supply with 20-120 psi
water pressure, as specified in the instructions.
Make sure the household water supply is connected and
turned on.
Check that the water supply line behind refrigerator is not
kinked.
Only use recommended water supply tubing, copper, or PEX,
as specified in the instructions.
Install water filter according to the instructions.
Flush water system with 3 gallons (11.4 L) of water, as
specified in the instructions.
Check for water leaks at all connections.
Turn on ice maker if refrigerator is connected to water supply.
(If not connected to water supply, turn off ice maker.)
6
Power Outage Indicator
If the power should go out while you are away from home, this
indicator will let you know that the refrigerator has been without
power.

GETTING STARTED

✔ Final Checks
Install air filter and Produce Preserver according to instructions
in corresponding packaging.
Remove all shipping material.
Set temperature controls to the recommended setting.
Save instructions and other literature.
Send in registration card or register your product online.

WATER FILTER INSTALLATION

Locate the water filter compartment in the lower left-hand side
of the refrigerator compartment. Push on the right side of the
filter door to open.
Align the arrow on the water filter cap with the cutout notch in
the filter housing and insert filter.
Once the filter is inserted, turn the filter clockwise 90° (¼ turn)
until it locks into the housing.
Push water filter door closed to latch.
Flush 3 gallons (11.4 L) of water through the water system to
clear air from the water line and to keep the dispenser from
dripping and/or avoiding decreased dispenser flow.
NOTE: If the filter is not installed correctly, water may
dispense at a lower flow rate and there will be slower ice
production. Improper filter installation may also cause the
water filter housing to leak.
To view videos on door removal/
replacement, door adjustment, water
filter installation, air filter installation,
shelf adjustment or removal, and Wi-Fi
(if applicable) connectivity, scan the code
to the left with your mobile device.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido