Unpacking The Washer - GE WSSH300 Manual Del Propietario E Instrucciones De Instalación

UNPACKING THE WASHER

WARNING:
bags after the washer is unpacked. Children might use
them for play. Cartons covered with rugs, bedspreads,
or plastic sheets can become airtight chambers
causing suffocation. Place all materials in a garbage
container or make materials inaccessible to children.
1. Cut the shipping carton along the dotted line along the
bottom. Remove the carton.
2. Using a rug, blanket or piece of cardboard to protect
the floor, lay the washer on its back.
3. Remove and save the styrofoam base and shipping
plug.
Base
Shipping
Plug
Installation Instructions
Destroy the carton and plastic
4. Carefully return the washer to an upright position.
5. Carefully move the washer to within 4 feet (122 cm) of
the final location.
6. Remove the following from the back panel of the
washer:
4 shipping bolts
4 spacers
1 metal "P" clamp
7. Remove the 4 plugs from the literature pack located in
the drum and install them in the holes vacated by the
packaging spacers.
Save all bolts, washers, spacers, brackets, clamps and
blocks for future use.
NOTE: If you must transport the washer at a later date,
you must reinstall the shipping support hardware to
prevent shipping damage. Keep the hardware in the
plastic bag provided.
Power Cord
Metal "P" Clamp
4 Shipping Bolts
4 Spacers
13