Toro Custom Command 36 Station Manual Del Usaurio página 19

For untimed operation:
. Press the
NEXT
A
wish to operate.
. Press the
ON
B
until one of the following occurs:
•The button is pressed
OFF
•The controller clock passes midnight
•The function dial is moved to another position
For timed operation:
. Press the
NEXT
A
to operate.
. Use the + and/or – buttons to set the desired amount of station
B
run time (for this operation only), from one minute to 10 hours.
. To select additional stations to operate in sequence, repeat steps
C
and as desired. Each station will operate one-by-one in the
A B
order they were selected.
. Leave the function dial in the Manual
D
position until the manual operation is complete,
then return the dial to the
PROGRAM CYCLE
Use this feature to manually operate watering programs. You can run
the entire program or start anywhere within the station sequence of
the program.
Note: Only the stations with an assigned run time in the program will
operate during the program watering cycle.
1. Turn the function dial to the Manual
2. Select Program
3. Press the
NEXT
sequence (if other than the station number displayed).
4. Press the button to start the watering cycle. Watering will start
ON
with the selected station and will be followed by all subsequent
stations. The display will show the run time remaining for the
operating station.
Note: You may advance through the stations by pressing the
key for the next station. To terminate operation at any time, press
the button.
OFF
5. Leave the function dial in the Manual
position until the manual operation is complete, then return the
dial to the
Run
Operating the Controller
button as necessary to display the station you
button. The station will turn on and remain on
button as necessary to display a station you wish
Run
, , or with the
A B C D
button to select the first station of the watering
position.
Single Station
position.
Program Cycle
switch.
Program
Program Cycle
position.
NEXT
17