Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
battery pack.
Indicators
Charging
Fully Charged
Hot/Cold Pack Delay
Bad Battery
Bad Battery
If you see a bad battery blink pattern, do not continue
to charge this battery. Return it to a service center or a
collection site for recycling.
hot/Cold Pack Delay
When the charger detects a battery pack that is too hot
or too cold, it automatically starts a Hot/Cold Pack Delay,
suspending charging until the battery pack has reached an
appropriate temperature. The charger then automatically
switches to the pack charging mode. This feature ensures
maximum battery pack life.
A cold battery pack will charge at a slower rate than a warm
battery pack. The battery pack will charge at that slower rate
throughout the entire charging cycle and will not return to
maximum charge rate even if the battery pack warms.
State of charge indicator
The battery is equipped with a state of charge indicator.
This can be used to display the current level of charge in the
battery during use and during charging. It does not indicate
tool functionality and is subject to variation based on product
components, temperature and end-user application.
Checking state of charge during use:
•
Press the state of charge indicator button.
•
The three LEDs will illuminate, indicating the percent of
charge in the battery. See chart in figure B.
•
If LED light does not illuminate, charge battery.
Figure B
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
WARNING:
tool or any part of it. Damage or personal injury
could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
Never modify the power
INTENDED USE
This hedge trimmer is designed for residential trimming
applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This hedge trimmer is a residential power tool. DO nOT
let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
OPERATION
WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. C)
WARNING:
button is engaged to prevent switch actuation before
removing or installing battery.
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
11
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Figure C
11
Proper Hand Position (Fig. D)
WARNING:
serious personal injury, ALWAYS use proper hand
position as shown.
WARNING:
serious personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Always hold the trimmer, as shown in the illustrations in
this manual, with one hand on the switch handle and one
hand on the bail handle (figure D). Never hold the unit by
the blade guard.
English
To reduce the risk of
Make certain the lock-off
10
into the tool handle, align the
To reduce the risk of
To reduce the risk of
7
Publicidad
Tabla de contenido
