Connecting The Water Supply; Installation Procedure - AEG RMB96716CX Manual Del Usuario

18 www.aeg.com

9. CONNECTING THE WATER SUPPLY

Water supply kit
Check the parts below for installing water
supply.
WARNING
To avoid electric shock, which
can cause death or severe
personal injury, disconnect the
refrigerator from electrical power
before connecting a water supply
line to the refrigerator.
1. When installing the water tubes,
ensure they are not close to any hot
surface.
2. The water filter only "filters" water;
it does not eliminate any bacteria or
microbes.
3. If the water pressure is not high
enough to run the icemaker, call the
local plumber to get an additional
water pressure pump.
4. The filter life depends on the amount
of use. We recommend you replace
the filter at least once every 6
months, (look at "changing the filter").
5. Use sealing tape to every connection
of pipes/tubes to ensure there is no
water leak.
6. The water tube should be connected
to the cold water line.

Installation Procedure

Join Connector to the tap water line
7. Remove plastic cap from water valve
inlet and discard cap.