Auto-Arm/Disarm Control; User Call-Up; Engineer's Reset; Keypad Configuration - DSC HS2TCHP Manual Del Usuario

Options Menu
All smoke detectors must be tested by your smoke detector installer once a year to ensure proper oper-
l
ation.

Auto-Arm/Disarm Control

Pressing Auto-Arm while in the User Function menu will enable (three beeps) or disable (one long beep) the
Auto-Arm and Auto-Disarm feature, by partition. With this feature enabled, the panel will automatically arm in
Away mode (Stay/Away zones active) or disarm at the same time each day. The Auto-Arm time is programmed
with the Auto-Arm time button. Auto-Disarm must be programmed by the system installer.

User Call-up

This option gives your service provider temporary access to the alarm control panel for remote servicing.

Engineer's Reset

If an alarm has occurred on your system, the system will not allow you to rearm (Ready light is OFF). You will
need to contact your installer. They will check and reset the system for you. This may involve a visit to check
your system. After the reset is performed, your system will function properly again.

Keypad Configuration

Figure 9- Keypad Configuration
Display Options:
sets the brightness and screen timeout of the Touchscreen, as well as screen saver options.
Buzzer Control:
sets the buzzer volume of the Touchscreen. Note: For SIA CP-01, the buzzer volume shall not
be placed at the minimum setting.
Note: For UL/ULC installations, the buzzer level shall not be changed from the default level.
Picture Frame:
selects the pictures that will be displayed on the slideshow.
Calibration:
calibrates the Touchscreen.
Clock Mode:
displays the digital clock.
Clean Mode:
allows the user to touch (i.e., clean) the screen without enabling or disabling any functions. The
screen will remain in this mode for 30 seconds, then return to the Keypad Configuration screen.
- 21 -