User Code Attributes; Inherent Attributes (All Codes Except Installer And Maintenance); Programmable Attributes; Bell Squawk Attribute - DSC HS2TCHP Manual Del Usuario

Options Menu
3. Select Prox Tag Prog then delete.

User Code Attributes

1. The default attributes of a new code will be the attributes of the code used to enter User Programming
whether it is a new code or an existing code being programmed.
2. System Master Code 01 has partition access for all partitions, as well as attributes 3-4 ON by default.
Note: These attributes are not changeable.

Inherent Attributes (all codes except installer and maintenance)

Arm/Disarm:
Any access code with partition access enabled will be valid for arming and disarming that par-
tition.
Command Outputs ([*][7][1], [*][7][2], [*][7][3], and [*][7][4]):
entry, any Access Code with partition access will be valid for performing the command output functions on that
partition.

Programmable Attributes

1. Supervisor Code
2. Duress Code
3. Zone Bypassing Enabled
4. Remote Access

Bell Squawk Attribute

This attribute is used to determine whether an access code should generate an arming/disarming Bell Squawk upon
entry of the code for Away arming. The wireless keys with access codes associated with them may generate Arm-
ing/Disarming Bell squawks. If desired, this option may be used with codes that are manually entered. Please con-
tact your installer to have this programmed.
Note: The Master Code cannot use the Bell Squawk attribute, but is required to enable it for other codes.
Note: This feature cannot prevent the Arming/Disarming squawks from being generated if an access code assigned
to a wireless key is manually entered at a keypad.
Note: This feature is used to annunciate fire trouble signals and also trouble conditions for medical applications.

Partition Assignment

1. This section is used to assign users to available partitions. To assign partitions:
2. Select Options > Access Codes.
3. Enter the master code.
4. Select a user.
5. Select Partition Attributes.
6. Select the partition(s) to assign to the user.
Notes on Access Codes and Programming
The master code's attributes cannot be changed.
l
When a new code is programmed in User Programming it will be checked against all other codes in the
l
system. If a duplicate code is found, an error tone is given and the code is returned to what it was before
it was changed. This applies to both 4 and 6-digit codes.

Erasing an Access Code

To erase a code, select the code and choose Delete User. The system will delete the code immediately and the user
will be returned to select another code.

Installer Menu

These functions are for the installer's use only.
5. For Future Use
6. For Future Use
7. Bell Squawk upon Arming/Disarming
8. One Time Use Code
- 19 -
If these outputs require access code