Xylem SI Analytics TitroLine 5000 Manual De Instrucciones página 121

Fig. 86
Generally applicable titration parameters
Depending on the titration mode (dynamic, linear and end-point titration), it is possible to enter a
variety of parameters. The following parameters are valid for all automatic titration modes:
•
Measured value (pH, mV)
•
Measurement speed
•
Initial waiting time
•
Pre-titration
•
Titration end
But please note that the measurement speed and the titration end differ again as a function of the
respective titration mode.
<Measured value> is the first selection to be made. In the present example, the selection is "pH".
Fig. 87
The selected measured value is displayed for information.
Fig. 88
121