HQ-Power PROMIX66N Manual Del Usuario página 5

PROMIX66N/PROMIX88N
17. PHONES Output
The PHONES output will feed headphones and is a 1/4" TRS jack, wired as tip = left signal, ring = right signal,
sleeve = ground.
18. AUX SEND
This is a master control that adjusts the output signal level at the AUX SEND (12) jack.
19. AUX RETURN Control
The left and right return signals will be routed to the AUX RETURN level control and mixed into the left and right
stereo OUT (13) while maintaining stereo separation.
20. PHONES/CONTROL ROOM CONTROL
The mixer allows you to monitor the MASTER
MIX. The signal level is adjusted with the
PHONES / CONTROL ROOM control and routed to
both the CONTROL ROOM (16) and
HEADPHONES (17) outputs.
21. LED OUTPUT Meter
The 10-stage LED OUTPUT meter displays the
MASTER MIX output level.
22. PHANTOM POWER ON/OFF Switch
When using condenser microphones, +48 VDC
can be switched globally on or off to the XLR
MIC inputs for all mono channels. When this
switch is in the "ON" position, the PHANTOM
POWER ON LED (25) will light and +48 VDC will
be provided between pins 2 and 3 on all the
mono MIC input XLR connectors. If you do not
need phantom power, be sure to turn this switch
to the "OFF" position.
Note: It is safe to connect balanced dynamic
microphones or line-level devices even if this
switch is on, but connecting unbalanced devices
or devices whose transformers are centre-
grounded will cause hum or malfunctions.
Shorting the +48 VDC can also damage your
mixer. Also, mute the monitor or PA speakers
first when turning the phantom power on or off.
23. TAPE / REC TO CONTROL ROOM Switch
Use the TAPE / REC TO CONTOL ROOM switch to route signals from the TAPE input (14) to the PHONES /
CONTROL ROOM control (20).
24 TAPE / REC TO MASTER Switch
Use the TAPE / ECHO TO MASTER switch to route signals from the TAPE input (14) to the MASTER MIX GAIN
control (29).
25. PHANTOM POWER LED
The red +48V LED lights up when the phantom power is turned on.
26. POWER ON LED
The red LED indicates that the console is powered on.
DIGITAL EFFECTS Section
27. EFFECTS Display
Press either ECHO effect buttons to scroll in either direction through the 16 presets. The numeric effects display
will indicate which of the 16 effect presets has been selected.
28. ECHO EFFECT SELECT Buttons
The built-in DSP (Digital Sound Processor) offers 16 different preset level and echo intervals selectable by the
echo effect UP / DOWN buttons. The DSP processes the signal on the EFFECTS bus, which is the sum of the
mono and stereo channel inputs controlled by the EFF control (5).
V. 01 – 30/10/2012 5 ©Velleman nv