Installing Of Monitor; Wiring; Connection Of Videophone; Connecting An Electric Latch Or Lock - Extel WEVP 2100 E Instrucciones De Uso E Instalación

Important !
Seal the upper joint between the exterior plate and the wall with silicone (5)
b. Installing of monitor
1. Put the wall carrier in place.
2. Connect the wires coming from the outdoor station.
3. Connect the adaptor plug to the back of the monitor (without connecting it to the power supply).
4. Fix the monitor to the wall carrier.
5. Check that the installation is complete and connect the adaptor to the power supply.
N.B. : If the power supply cable is cut, check the polarity

5. WIRING

Important !
If you try the system before installing it, make sure the street unit and the monitor are not in the same room,
otherwise the videophone will emit piercing feedback noise.
a. Connection of videophone
Use the following wires:
1. Connect the wires securely following the wiring diagram (fig 5).
2. To connect the video camera, only 4 wires are needed for all the functions: chime, video image, intercom.
Caution :
Under no circumstances should the wired be doubled to make them thicker
Ensure that the colour coding of the wires is maintained when connecting the screen and the outdoor video camera
•Terminal "1" on the screen to terminal "1" of the video camera.
•Terminal "2" on the screen to terminal "2" of the video camera.
•Terminal "3" on the screen to terminal "3" of the video camera.
•Terminal "4" on the screen to terminal "4" of the video camera.
b. Connecting an electric latch or lock
Connect the lock directly to terminals 7 and 8 on the back of the monitor (no colour coding).
Note that this function is only valid when the screen is switched on. The image disappears briefly when the com-
mand is transmitted.
Important :
It is essential that the electric latch or lock installed has a mechanical memory like all products
marketed by Extel.
c. Connecting a gate opener
Connect the gate motor directly to terminals 5 and 6 on the back of the monitor. The monitor constitutes a dry
contact without power for the "push button" command of the automatic control.
Note that this function is only valid when the screen is switched on.
NL
(fig 4)
(fig 5)
• lengths up to 25 metres: 2 x 6/10 wires +2+2
• lengths between 25 and 100 metres: 2 x 1.5 mm
(fig. 5)
CFI EXTEL WEVP 2100 E SER.R2 - 10/2011 - V1
(fig. 5)
wires +2+2
2