Basics; Getting Started; Select The Display Language And Cancel The Demonstration - Kenwood DPX794BH Manual De Instrucciones

Basics

Remote control (RC-406)
(supplied for
Remote sensor
(Do not expose to bright sunlight.)
/ /
remotely controlled with an optionally purchased remote control.
How to replace the battery
To On the remote control
Adjust the volume Press VOL
• Press and hold VOL
the volume to 15.
Press ATT during playback to attenuate the sound.
• Press again to cancel.
Select a source Press SRC repeatedly.
Turn off the power Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
)
Pull out the insulation sheet when
using for the first time.
/ / : Can be
or VOL .
to continuously increase

Getting Started

1

Select the display language and cancel the demonstration

When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES], see page 7), the display shows: "SEL LANGUAGE" "PRESS"
"VOLUME KNOB"
1 Turn the volume knob to select [ENG] (English) / [SPA] (Spanish) /
[FRE] (French), then press the knob.
[ENG] is selected for the initial setup.
Then, the display shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB".
2
Press the volume knob again.
[YES] is selected for the initial setup.
3
Press the volume knob again.
"DEMO OFF" appears.
5
ENGLISH