Kenwood DPX794BH Manual De Instrucciones página 30

Bluetooth®
To On the faceplate
Adjust the phone Turn the volume
volume*1 knob during a call.
[00] to [35] (Default: [15])
Switch between hands- Press 6 IW during
free and private talk a call.
modes*2
*1 This adjustment will not affect the volume of the other sources.
*2 Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press and hold to exit.
To return to the previous setting item, press
[MIC GAIN] [LEVEL –10] to [LEVEL +10] ([LEVEL –4]): The sensitivity of the
microphone increases as the number increases.
[NR LEVEL] [LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
[ECHO CANCEL] [LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the echo cancellation
delay time until the least echo is being heard during a phone conversation.
24
ENGLISH
On the remote control
1
Press VOL or
2
VOL during a call.
• Press and hold
VOL to 3
continuously increase
4
the volume to 15.
To return to the previous setting item, press
( Not available )
[SETTINGS]
[AUTO ANSWER] [1] to [30]: The unit answers incoming call automatically in the selected
[BATT/SIGNAL]* [AUTO]: Shows the strength of the battery and signal on the supplementary
* Functionality depends on the type of the phone used.
Make a call
You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1
.
Default: [XX]
2
3
4
To return to the previous setting item, press
Make the setting for receiving a call
Press to enter Bluetooth mode.
Turn the volume knob to select an item (see the following table), then
press the knob.
Repeat step 2 until the desired item is selected or activated.
Press and hold to exit.
time (in seconds). ; [OFF]: Cancels.
display (page 42) when the unit detects a Bluetooth device and the
Bluetooth device is connected. ; [OFF]: Cancels.
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
other phone.
"(Second device name)" appears.
Turn the volume knob to select an item (page 25), then press the
knob.
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
Press and hold to exit.
.
Default: [XX]
again to switch to the
.