Miller Spectrum 625 X-TREME Manual Del Operador página 37

!
Turn power Off, and disconnect input power plug from receptacle.
Check to see that all diagnostic LED's have stopped flashing before
replacing any torch parts.
.
The ICE-40T torch is specifically for use only with this plasma cutting unit.
1
4
3
2
See Figure 8-1 for additional
consumable parts.
.
A complete Parts List is available on-line at www.MillerWelds.com
To maintain the factory original performance of your equipment, use only Manufacturer's Suggested
Replacement Parts. Model and serial number required when ordering parts from your local distributor.
5
1
Figure 8-2. Torch, ICE-40T
Item Part
No. No. Description
1 183 427 Handle Assy, complete (1)
2 192 059 Main Body (1)
3 185 833 Switch Assembly
w/spring (1)
4 190 220 Spring, trigger assembly
5 171 248 Push Button Switch (1)
169 231 Grease, silicone (1)
OM-237 974 Page 33
Ref. 803 386