To Install A Spacer (Accessory); To Change Drill Column - Husqvarna DS900 Manual Del Usuario

5. Tighten the lock clamp with the lock screw (B).
B
A

To install a spacer (accessory)

A spacer is necessary to use when the drill bit has a
large diameter. There are different types of spacers
available. Refer to the table for maximum drill bit
diameters for different spacers.
1. Install the spacer on the drill motor.
2. Attach the drill motor with spacer to the drill motor
carriage.
Drill mo-
tor
0
DM400 350/14
DM406 500/20
DM430 350/14
DM650 400/16
DM280/
350/14
DM340

To change drill column

Do this procedure to change between the standard drill
column and the 2 m drill column (accessory).
1324 - 001 - 11.10.2019
Spacer, mm/in.
50/2 2×50/2 200/7.9
N/A N/A
600/24 700/28 900/36
450/18 N/A
500/20 600/24 800/32
450/18 N/A
1. Loosen the jack screw and remove the end stop (A).
2. Unlock the drill motor carriage (B).
3. Remove the drill motor carriage (C).
4. Loosen the lock screws for the lock clamps that hold
the drill column to the support and the bottom plate.
N/A
N/A
N/A
5. Remove the drill column.
6. Install the drill column in the opposite sequence.
A
B
C
7