To Connect The Dust Extractor - Husqvarna CG 200 Manual De Usuario

3. Fit the drum and slid it on its shaft.

To connect the dust extractor

Always use a vacuum cleaner to minimize dust. Make
sure that the filters in the vacuum cleaner are intact and
clean. Pay attention to dust during operation.
Introduction
WARNING: Please read the operator's
manual carefully and make sure you
understand the instructions before using the
product.
WARNING: Wear personal protective
equipment. See
equipment on page 7 for instructions.
WARNING: Make sure no unauthorised
persons are in the working area, otherwise
there is a risk of serious personal injury.
WARNING: Check that the product is
assembled correctly and do not show any
signs of damage.
To start up
CAUTION: The operator position is behind
the product keeping both hands on the
handles. Maintain a safe distance to the
rotating tool. Make sure that no pipes or
electrical cables are routed in the working
area or in the material to be cut. Do not
leave the product unattended while the
engine is running.
Note: When the product is engaged it will move forward
uncontrolled due to the activated drum.
1. To start the product, grasp the operator presence
control handle on the steering shaft.
8
Operation
Personal protective
1. Connect the dust extractor (1) to the product.
2. The motor stops if operator presence control handle
(1) is released.
3. Check regularly that it operates correctly. Do not lock
it in position.
To start the fuel product
1. To start the motor, see the motor manufacturer
manual.
2. Let the motor warm up.
130 - 003 - 18.08.2017