Tabla De Contenido; Table Of Contents; Unpacking; Transporting - Husqvarna Soff-Cut 2000 Manual Del Operador

CONTENTS
Content
Table of contents ...................................... 2
Unpacking ................................................. 2
Transporting ............................................. 2
Introduction, personal safety .................... 3
General safety message ........................... 4
Safety warnings ........................................ 5
Excel series blades ................................... 6
Blade and skid plate installation ............... 6
What is what? ........................................... 7
Operating instructions ............................... 8
Fuel and fuel safety warnings ................... 9
Recommended fuels ................................. 9
Recommended oils ................................... 9
Engine and transmission maintenance ..... 10
Other maintenance ................................... 11
Sawing contraction joints .......................... 12
Maximizing the Soff-Cut system ............... 13
Troubleshooting ........................................ 14
............................ 15
.............................. 15
Warranty ................................................... 16
Your 2000 saw has been shipped from the factory thoroughly
Page
inspected. Only minimal assembly is required to start using
the saw. Remove the saw from the container using proper
lifting techniques. Discard or recycle the packing material per
your regional laws. In your container will be the 2000 saw,
blade shaft wrench, spark plug wrench, an owner's manual, an
engine owner's manual, a part list, a warranty card, a joint pro-
tector sample pack and a ramp for unloading the saw. Raise
the saw to its full height by pressing down on the handle bar.
Place the unloading ramp at the edge of the container and roll
the saw out of the container. Lower the saw by pressing down
on the handle bar and squeezing the lever on the handle bar.
NOTE: No diamond cutting blade or skid plate is included
with the saw. Purchase the appropriate Husqvarna Excel
Series 9 or 10 inch blade from your local Husqvarna
Construction Product dealer.
The 2000 saw weights approximately 342 pounds (155 kilo-
grams) when ready to use. Use safe lifting practices when
handling the saw. Always remove the diamond blade when
transporting the saw. Always transport the saw with a skid
plate installed. Fold the guide arm back. The saw can be lifted
from the center hook on the roll cage. Always store and trans-
port the saw in a completely lowered position and secured
from moving.
Handle bar
2

UNPACKING

TRANSPORTING

Front guide
Roll cage
Rear guide
CAUTION
Only use the center hook on the
roll cage when lifting the 2000.
Lifting point