Bartacking; Embroidery - Sears Kenmore 385.18221 Manual De Instrucciones

Tabla de contenido

Publicidad

BarTacking
_1_. Stitch selector:
3
_2_ Stitch width:
2 to 6.5
_3_' Stitch length:
0.5 to 1
_4_ Needle thread tension:
2 to 6
_5_ Presser foot A:
Zigzag foot
This is similar to a very short satin stitch, and is used to
reinforce points of strain such as corners, pockets and
straps of lingerie.
Sew four (4) to six (6) stitches.
_1_' Bar tack
f
Y
,_4/,
0--1
--2--3=4=5_6.5
sm_c_
LEr_GTH
V--0--_--_l_2__S__4
J
Embroidery
_1_Stitch selector:
3
_2_Stitch width:
1 to 6.5
_ Stitch length:
Any
_4_Needle thread tension:
2 to 6
.(5_Feed dogs:
Dropped
*
Presser foot:
Remove
Drop the feed dogs, and then remove the foot holder.
Adjust stitch width as desired. Draw a design onto the
fabric with tailor's chalk. Stretch the fabric between
embroidery hoops, and then place the fabric under the
needle.
Lower the presser foot lifter to engage the needle thread
tension. Holding the needle thread in your left hand, rotate
the handwheel counterclockwise
for one complete turn.
Pull the needle thread to draw the bobbin thread to the right
(top) side of the fabric. At medium speed, stitch along the
marked outline, guiding the fabric carefully by hand. After
embroidery is completed, raise the feed dogs for normal
sewing.
f
Y
f-\
J)
,
_
_
WIDTH
0--1
--2--3=4=5_6.5
S_
_4_,
)
X
J
"x
52

Publicidad

Tabla de contenido
loading

Tabla de contenido