Section Ii. Getting Readyto Sew Connecting Machine To Power Supply; Before Using Your Sewing Machine; For Your Safety; Polarized Plug - Sears Kenmore 385.18221 Manual De Instrucciones

Tabla de contenido

Publicidad

SECTION
II. GETTING
READYTO
SEW
Connecting
Machine to Power Supply
_1_ Power supply plug
(2_' P ower switch
(3_Outlet
_4_ Machine socket
@ Machine plug
@ Light bulb
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch _2_.
2. Insert the machine plug@ into the machine socket _4_.
3. Insert the power supply plug _1_, into the outlet _3_.
4. Turn the power switch :_to turn on the power and
sewing light ,_6_'.
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended.
- When attaching or removing any parts.
- When cleaning the machine.
* Do not place anything on the foot control, when not
sewing.
Polarized
plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Foot Controller Model YC-482J -1 or TJ C-150 is used with
Sewing Machine Model 385.18221.
f
S
/
\\
\\\\\
\
/
/
/
J
J
x
Controlling
Sewing
Speed
Sewing speed is varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
,i
,.
j
6

Publicidad

Tabla de contenido
loading

Tabla de contenido