Section Vii. Buttonhole; Automatic Buttonhole; Preparation For Sewing; To Sew - Sears Kenmore 385.18221 Manual De Instrucciones

SECTION VII. BUTTONHOLE
Automatic Buttonhole
_i) Stitch selector:
_2_Stitch width:
,_3_ Stitch length:
_4_Needle thread tension:
_5) Presser foot R:
II (BH)
3 to 6.5
0.25 to 1.0
2to6
Automatic buttonhole foot
• Preparation for sewing
(i) Groove
_2_Pin
Attach the automatic buttonhole foot R. Make sure the
groove on the foot holder catches the pin on the foot when
lowering the presser foot.
f
f
0--1 --2--3_4_5_6,5
_;_'°" o---= .... _2_ _"
J
-x
to$ ew
'J_ Button holder
_2_Buttonhole lever
The buttonhole size is automatically set by placing the
button in the rear of the automatic buttonhole foot.
The button holder on the foot takes a button up to 1.0"
(2.5 cm) in diameter.
Make a test buttonhole on an extra piece of the fabric to
check your settings.
Use interfacing on stretch fabrics.
[] Pull the button holder'_!)to the back, and place the
button in it. Push it forward tightly against the button.
[] Pull the buttonhole lever ,_2_) down as far as it will go.
[]
/
,\1_i
\\\\
J
-x
,. j
74