Cabin Switch - Dhollandia ELEC GENERAL 02 Instrucciones De Montaje

EN

2. CABIN SWITCH

The cabin switch on the dashboard in the vehicle cabin
can execute 2 functions :
1. on/off switch for the electric power to the exterior con-
trol box
2. signal if the platform is stored in road position or not
Most truck manufacturers offer this switch as an option,
together with an electrical "VEHH" interface (electrical
cable with 7-pin Cannon plug available at the rear of the
truck chassis).
It is possible to retrofit a different cabin switch. For in-
stance Dhollandia's option S078 [See 1 on Fig. 2.1]. In
this case, the electrical cable and interface must be
mounted by the installer of the HTL.
Cabin switch Interface
Original from VEHH
truck brand ♀
7-pin Cannon plug
Dhollandia S078 none
In case of VEHH interface + option S070, plug the
non plug S070 from the power pack of the HTL in the
cannon plug on the vehicle chassis, and test all functions.
In the other case, mount the cabin switch S078 on a posi-
tion on the dashboard that is clearly visible from the
driver's seat. Mount the 4x1.5mm² cable S070.12 from the
cabin switch to the power pack of the HTL, following the
wiring diagrams in the annexes.
Fig. 2.1
1 Cabin switch
2 VEHH interface
3 S070 7-pin cannon plug
4 Control power from cabin switch to exterior control
box
5 Selection switch in the control box
DHOLLANDIA
2.1
Dho option to order
S070
♂
7-pin Cannon plug
S078
S070.12
♂
can-
♀
5
2
3
4
11
1