Leckey squiggles Instrucciones De Usuario página 10

7.3 Attaching stander to
pivot chassis
To attach the stander to the Pivot Chassis,
pull the locking pin out, slide the central
spine into the receiving bracket until it is
fully engaged, release the pin allowing it to
snap back into place.
Always make sure the locking pin is
fully engaged before you place the
child in the stander.
7.4 Attaching stander to
Easel chassis
To attach the stander to the Easel chassis
engage the central spine into the receiving
bracket until it is fully engaged. Release
the locking pin at the side of the pedal by
pulling and rotating it through 90 degrees
into the locked position. Press the pedal
down and locate the locking bar at the base
of the central spine in the recess. Release
the pedal, the support frame is locked into
position. Release the locking pin again so
the pedal cannot be accidentally released.
Always make sure the locking pedal is
fully engaged before you place the child
in the stander.