Troubleshooting; Identifying And Repairing Faults - Invacare Aquatec Pure Bidet Manual Del Usuario

9 Troubleshooting

9.1 Identifying and repairing faults

Fault
Unit does not operate at all
CLEANSING, BIDET, DRY, AUTO do not
operate
Remote control does not operate at all
Malfunction of the remote control
No water spray
Low water pressure
1590625-D
Possible cause(s)
Power is off
Power plug is not connected
There is a power failure
Seat is covered
Batteries in the remote control have
been exhausted
Batteries are empty or too weak
Remote control out of reach of the
device
The shut off valve is closed
There is water supply outage
The water pressure level is set to "LOW" Increase water pressure level,
The water strainer is clogged
Nozzle head is dirty
Remedy
Press any button to check except "HIGH",
"LOW", "FRONT" or "BACK" buttons of
the remote control.
Make sure that there is nothing on
the seat surface. (The device is only
activated when the user's skin touches
the seat sensor.)
Replace batteries with new ones,
→ 4.1 Installation / Assembly, page 12.
Replace batteries with new ones,
→ 4.1 Installation / Assembly, page 12.
Open shut off valve.
Restore water supply.
→ 5.3 Using the shower toilet, page 19.
Clean water strainer, → 7.2.3 Cleaning,
page 26.
Clean nozzle, →7.2.3 Cleaning, page 26.
Troubleshooting
29